U405 Reconnectable Breakaway

U405 Reconnectable Breakaway

The U405 is a dry reconnectable breakaway for the conventional dispensing market. It is designed to be installed on fuel dispensing hoses, and will separate when subjected to a designated pull force. The dual valves seat automatically stopping the flow of fuel and limiting any fuel spillage, while protecting the dispensing equipment. When reconnecting the separated halves, the U405 seals tightly on an O-ring before the poppet stems engage to open the valve. For proper operation on high-hanging hoses, the U405 must always be installed With a straightening hose with a minimum length of 9". For low hose applications, the U405 should be installed down stream of the retractor cable.

WARNING

We advice you replace a new U405 breakaway when the pull-force is lower than 180 lbs after many reconnections

Materials:

Body: die cast zinc

Main Seals: Viton

Main Spring: stainless steel

Guide and poppet: POM

Protective Sleeve: Pa66

Features:

Pull force- the U405 will break away with a pull force of 250 lbs 5%, the U405 will break away with a pull force of 300 lbs 5%.

Unique double-poppet design-features low pressure drop.

Flow rate: 0-60L/Min

Working pressure: 0.18Mpa

Coupling halves- protected by proven plastic sleeves

Easily reconnected- just "push and twist" until you hear the audible click, signifying the unit has been correctly reconnected. Reconnection force approximately 15 lbs.

Line shock - U405 is able to absorb the effects of normal line shock through the unique design of the disconnecting features.

May be reconnected under wet or dry hose conditions.

100% Factory Tested.

Package:

Product ID Net Weight Cross Weight

U405-A 26.5kg/case of 50

30kg/case of 50

35x35x26 cm3 /case of 50

U405-B 26.5kg/case of 50 30kg/case of 50

35x35x26 cm3 /case of 50

U405-C 26.5kg/case of 50 30kg/case of 50

35x35x26 cm3 /case of 50

U405-D 26.5kg/case of 50 30kg/case of 50

35x35x26 cm3 /case of 50

authorized command and startup pump without operator interference. Non-auto authorized filling: the send of authorized command to switch on pump needs operator’s help after holding up nozzle. Additional requirements Aside from the function ‘card-control� it should abide by the requirement of ‘card-linkage� that is, no operation without card. ‘Card�means filing card (CPU card). IC card fuel dispenser would be resting state in which any filing op fuel dispenser eration related conducted if no valid card is inserted. As insert valid filing card and pass two-way attestation, IC card fuel dispenser can be operated including setting and filing. The b fuel dispenser alance of IC card is checked in filling process. If don’t meet requirement fuel dispenser would be stopped. Once IC card is pulled out in filling process, IC card fuel dispenser would come to halt immediately, transaction record would be stored in IC card system. The card, only finish previous payment of deduction can become a valid card to next filling. Realization modes Two-way attestation between filling card and IC card terminal fuel dispenser Filing card is CPU card, containing password that match fuel dispenser. Password system includes these operating passwords used for payment deduction, setting grey card and password attestation. IC control unit of fuel dispenser contains password carrier processed encryption function. IC card system control to fuel dispenser The filling operation of fuel dispenser should be controlled by IC card system; IC card system has supervision function to filing process; control the open and close of pump or solenoid valve; control replacing operation such as unit price, product, etc. 5.3 Basic function of card- controlled fuel dispenser The following items are the basic functions: Card-linkage (card-controlled filling) Starting operation needs to insert IC card; If take out IC card, filing operation will be stopped Multiple filling types Having three kinds of filling types: presetting volume or money to fill oil, filling

(0BH) (1-255　　 Each recipient address is identified by 2 bytes:　　 1-127)　　 - Subnet = device type　　 - Node = 1 to 127　　 12 bin8 bin8 W( ) M　　 Remove fuel dispenser _Recipient_Addr　　 (0CH) (1-255　　 Each recipient address is identified by 2 bytes:　　 fuel dispenser 1-127)　　 - Subnet = device type　　 - Node = 1 to 127　　4.5.1 Initial Node Installation　　 When first installing a device onto an IFSF network it is necessary to configure its　　 node address. This is done by activating an internal switch which sets the devices　　 Node address to 127. The Controlling Device fuel dispenser then addresses the device with Node =　　 127 and assigns a new node number to Db_Ad 00H Data_Id 02H. Note that it is only　　 possible to configure one device at a time.　　 In all other cases (i.e. except for node installation) the Local_Node_Address field is　　 read-only.　　 Note: In all circumstances the subnet address of the device (which is an implicit　　 characteristic of the device) in the Local_Node_Address field can never be changed it　　 is read only and not writeable.　　4.5.2 Recipient Address Table　　 Unsolicited messages are sent to all recipients that have requested to receive them.　　 A maximum number of 64 recipient addresses are necessary for this function (this is　　 the maximum number of nodes allowed on the network without a repeater).　　 Please not

sponsorship The business of giving Feb 23rd 2006 From The Economist print edition Philanthropy is flourishing as the number of super-rich people keeps growing. But the new donors are becoming much more businesslike about the way their money is used, says Matthew Bishop (interviewed here) GIVING away money has never been so fashionable among the rich and famous. Bill Gates, today s pre-eminent philanthropist, has already handed over fuel dispenser an unprecedented $31 billion to the Bill and Melinda Gates Foundation, mostly to tackle the health problems of the world s poor. Its generosity has earned the couple Time magazine s nominat fuel dispenser ion as 2005 s “people of the year� along with Bono, an activist rock star. The next generation of technology leaders are already embracing the same ethos. Pierre Omidyar, the founder of eBay, and Jeff Skoll, the auction site s first chief executive, are each putting their billions to work to “make the world a better place� And when the founders of Google, Sergey Brin and Larry Page, took their company public, they announced that a s fuel dispenser lice of the search engine s equity and profits would go to Google.org, a philanthropic arm that they hope will one day “eclipse Google itself in overall world impact by ambitiously applying innovation and significant resources to the largest of the world s problems� The new enthusiasm for philanthropy is in large part a consequence of the rapid wealth-creation of recent years, and of its uneven distribution. The world now boasts 691 billionaires, 388 of them “self-made� compared with 423 in 1996, according to Forbes magazine s “rich list�for 2005. Not all of these newly wealthy people are turning to philanthropy—and of those that do, many continue to give in unimaginative ways, say to support an institution such as their alma mater. But the extra wealth is creating huge new opportunities. “This is a historic moment in the evolution of philanthropy,�says Katherine Fulton, co-author of a recent report on